Rubber Press Seals
GPD Rubber Press Seals
No matter what type of cable is to be led through walls or ceilings - UGA's system GPD always offers a safe solution.
UGA Rubber Press Seals can be inserted into the most varied pipe linings, diamond tipped drilled holes or entrance plates without any problems.
Rubber Press Seals GPD are used for protecting pipes and cables. They can be installed in a pipe lining as well as directly into a diamond tipped drilled hole.
GPDs also serve as a guide and for acoustic uncoupling. When tightening the hexagon nuts the rubber disc is displaced by the press plates. Thus a secure and permanent sealing is accomplished even under water pressure which can be released at any time.
Available with a rubber thickness of 30 mm for sealing against non-pressing water and a rubber thickness of 60 mm for pressing water.
The "one-piece design" is suitable for installation during plumbing and wiring. For installation of the GPD after plumbing and wiring or under difficult conditions a "divided design" is required.
Pipe linings will be supplied fitting to the wall thickness of the structural works and are imbedded flush into the formwork. Upon supply our plastic pipe linings are closed with PE covers on the front side and are thus prepared for imbedding into the concrete. In case of fibre cement and stainless steel pipe linings special concepts for project-related applications are also possible, as e.g. design with integral / slip-on type flange (basement waterproofing) to DIN 18195 part 9.